YAK 130
BVM ©2016 14 Mar. 23, 2016
Spot Gluing the Inlet Ducts into the Fuse
(See also next page.)
NOTE: The aft end of the Inlet Ducts are temporarily held together with (2) #64 rubber bands.
Use clothes pins or small clamps to hold for cure.
Use Zap-A-Gap or Slo-Zap to glue the Aft bottom and top of the Inlet Ducts at the rear
end.
Bottom Joint Top Joint
Use dabs of a thickened epoxy glue to secure the Inlet Ducts to the fuse as shown below.
Aeropoxy is convenient for this task.
NOTE: If Inlet Ducts ever need to be removed, use a Dremel fiber cut-off wheel to separate
the joint.
Right Side Left Side
To Next Page
Loading...
