YAK 130
BVM ©2016 42 Mar. 23, 2016
Apply BVM’s “Super Lube” to the axle and
bushings in both sides of the wheel.
Apply a thin finger wipe of BVM “O” lube to
the inside surface of the brake drum. A very
small amount helps to keep the brakes from
grabbing.
NOTE: A taxi test will confirm that the braking
action is smooth and sufficient.
NOTE: The brakes are either “on or off” in
function. The “on” condition does not lock-up
the wheels.
Re-assemble the wheel/axle onto the strut
for a trial fitting. Check that the set screws
are engaging the flat spots on the axles
properly.
NOTE: There should be a white Teflon washer
on each side of the wheel.
For final assembly, apply a drop of Z-42 to
each set screw and tighten them securely.
To Next Page
Loading...
