BYD SEAL U DM-i - Page 102

●
Charging time: Refer to the charging
time message on the instrument
cluster.
2. Charging
Connect the vehicle to a DC charging pile
by the charging connector of this pile to
begin DC charging.
Instant charging method:
●
Before charging, power o󽗈 the vehicle.
●
Unlock the vehicle and open the
charge port door and cap:
●
For the speci󽗉c operation, refer
to the relevant procedures for
Household Portable AC Charging.
Open the charging port hatch
󽗉rst and open the charging port
protection cover from the top down.
●
Connect the vehicle port:
●
Connect the charging connector of
the charging pile to the charge port,
and lock it securely in place.
●
Operate the charging equipment to
start charging.
●
The charging connection indicator
on the instrument cluster lights up.
●
In the charging process, the instrument
cluster displays relevant charging
parameters and the charging sign.
3. Stopping charging
●
End the charging:
●
Charging ends automatically when
early stop time is due or the charging
is complete.
●
Unplug the charging connector:
●
After the instrument cluster displays
that charging is completed, pull out
the charging connector.
●
After DC charging with a charging
pile, properly place the charging
equipment. Put the charging
connector to the designated position
of the charging pile.
●
Close the charge port cap (from
bottom to top) and the port door.
REMINDER
●
During charging at a high/low
temperature, it is normal
that the battery thermal
management performance may
be a󽗈ected by the A/C in the
passenger compartment, causing
an extension in the charging time.
CAUTION
●
After charging, if the charging
connector cannot be pulled out,
please contact customer service
personnel for the charging pile
immediately.
●
See the charging instructions for
speci󽗉c charging precautions.
WARNING
●
See section "Charging
Instructions" for charging safety
warnings.
101
04
USING AND DRIVING