BYD SEAL U DM-i - Page 117

Fault Possible cause Solution
repair it as quickly as
possible.
Driving with a trailer
●
Trailer hitch
●
If the optional trailer hitch kit is
selected by the user, an additional
toolkit is provided for the trailer hitch.
●
After use, remove the trailer hitch and
place it into the dust bag. Place the bag
in the toolkit to prevent rust.
Installing the trailer hitch
1. Remove the guard plate from the
bottom of the rear bumper, and take
out the hitch body from the storage
bag.
2. Pull up the hitch housing dust cover.
3. Insert the key into the hitch's locking
cylinder and turn it anticlockwise.
4. Press and hold the knob switch, while
turning it clockwise to the red area.
5. Firmly grasp the hitch from the
bottom and align the triangle marks
on both sides of the hitch with the
corresponding cutouts in the hitch
housing.
6. Push the hitch into the hitch
housing until the knob switch rotates
anticlockwise by about 110° and
automatically locks into the "Closed
Position". At this time, the knob switch
is turned to the green area.
7.
Visually check that the hitch is fully
inserted into the housing. Try pulling
down on the hitch to con󽗉rm that the
hitch does not drop.
8. Turn the key clockwise to lock the
hitch, take the key and store it properly
(preferably inside the vehicle).
9. Close the dust cover to prevent dirt
and debris from entering the lock.
WARNING
●
Be sure to use the BYD SEAL U
DM-i trailer hitch when towing a
trailer. Never attempt to attach a
di󽗈erent type of trailer hitch.
Removing the trailer hitch
116