3 Pins 1-8 GND
4 Right turn signal
5 Right taillight
6 Parking light
7 Left taillight
8 Reverse light
9 12V power supply - permanent
10 12V power supply - switch/ignition
11 Pin 10 GND
12 Reserved (not connected)
13 Pin 9 GND
CAUTION
●
The driver shall ensure that
all electrical connections and
all trailer lights are operating
normally before and during
towing.
●
When the electrical connection
device is not connected to the
trailer interface, do not directly
clean this device with a high-
pressure water jet. Doing so
may result in water entering and
damaging the device.
WARNING
●
Use only the electrical connection
device designed by BYD. Do not
directly splice or connect the
trailer’s electrical circuit using
any other method. Doing so can
damage the vehicle electrical
system and cause faults.
Guide for activating trailer mode
●
Preparation before connection
●
Take out the trailer hitch from the
toolkit in the boot and insert it into
the reserved interface at the rear of
the vehicle;
●
Shift the vehicle to R, and enable
the towing assist function on the
panoramic view screen;
●
Reverse the vehicle with the aid of
the towing assist guide cursor in the
reverse image, and make the trailer
hitch ball close to the mechanical
connecting device of the vehicle to
be towed;
●
Connecting the two vehicles
●
Connect the two vehicles according
to instructions of the vehicle to be
towed.
●
When stationary, the vehicle
automatically enters the trailer mode
after the cable is connected.
●
Light detection
●
Automatic: Light detection
automatically starts 15s after the
cable is connected.
118
To Next Page
Loading...
