16 cab Produkttechnik GmbH & Co KG
Cutter Unit
With the cutter unit installed, labels or continuous media may be cut when
desired. Cutter options include a choice of: after each label, after a specific
quantity of labels, or at the end of a print job. For cutter operation, the printer
firmware will extend the label for cutting based on specified displacements,
then automatically backfeed the label, so that after making a cut, the label roll
will be repositioned and ready for printing the next label.
The cutter is powered directly by the printers peripheral connector.
A3 A4 A6
Cutter 1 (up to 200g/sqm) x x -
Cutter 2 (up to 300g/sqm) - - x
Cutter 5 (up to 300g/sqm) x x -
Memory Card
The printer includes an option for using memory cards in order to permanently
store graphics, fonts or whole label formats. The data can be downloaded via
any of the printers data interfaces. CompactFlash Type 1 cards with a
maximum capacity of 64 MB are accepted. Using a memory card, the printer
can be operated without being connected to a computer which represents a
great advantage regarding the flexibility.
External Keyboard
The keyboard connector allows you to connect your printer to an USB
keyboard. This will allow you to input variable data to a format stored on a
memory card.
Interface Extensions
The printer is equipped with a slot to connect an additional interface.
It is possible to install a RS-422/485 interface, an USB interface or an
ethernet interface allowing the printer to be connected to several different
types of interfaces and networks.
1. Product Description
To Next Page
Loading...
Need help?
General
