43cab Produkttechnik GmbH & Co KG
Preparation for Tear-Off Mode / Rewind Mode
The R-version printers are delivered with the rewind guide plate (1) mounted
for operation in rewind mode. With the optional tear-off plate the printer also
may be operated in tear-off mode. For this purpose the rewind guide plate (1)
must be replaced by the tear-off plate (3).
The P-version printers are prepared for the dispense mode. After mounting the
optional tear-off or rewind guide plate the printers also may be operated in tear-
off or rewind mode.
2
2
3
1
7. Media Loading
Fig. 7b Exchange Rewind Guide Plate / Tear-Off Plate
The exchange of the different plates can be made in a similar way as the
exchange rewind guide plate / tear-off plate :
1. Open the cover.
2. Loosen the two screws (2).
3. Slide the rewind guide plate (1) to the right as far as possible to remove the
plate from the printer.
4. Place the slotted holes on the tear-off plate (3) over the screws (2) on the
front of the printer and slide the plate to the left until it stops.
5. Tighten the two screws (2).
To Next Page
Loading...
Need help?
General
