To Next Page

To Previous Page

42 cab Produkttechnik GmbH & Co KG

1 2

7. Media Loading

General Information

1. Pay attention to the specifications of the material indicated in chapter 1 .

2. When using the printer for the first time or using label media with a different

width, make sure to adjust the printhead support as well as the position of

the label edge sensor.

3. There are warning labels on the media hub and on the ribbon supply hub

which will be visible if the material is getting low. When these warning

labels are visible, prepare to replace the material soon.

1 - Warning label "End of Ribbon"

2 - Warning label "End of Paper"

4. If you do not use the printer for an extended period of time, lift the printhead

to avoid possible flattening of the print roller.

5. If you want to move or ship the printer to another location, remove the

media and the ribbon from the printer.

Fig. 7a Warning labels

7. Media Loading

Other manuals for CAB a3-2

Questions and Answers:

Need help?

Do you have a question about the CAB a3-2 and is the answer not in the manual?

General