Section 2: Pump Setup and Programming
Pump Setup &
Programming
28
Air Detector
is screen indicates whether the Air Detector is on high sensitivity,
low sensitivity or turned o. e Air Detector status cannot be changed
without entering the Biomed Functions Code (see Section 4, Biomed
Functions, to change the setting).
Upstream Sensor Status
is screen indicates whether the Upstream Occlusion Sensor is turned
on or turned o. e Upstream Sensor status cannot be changed without
entering the Biomed Functions Code (see Section 4, Biomed Functions,
to change the setting).
Before programming in Intermittent Delivery Mode:
• Stop the pump and change the Lock Level to LL0 as described in Section 1.
• Select the Intermittent Delivery Mode (IDM) as described in Chang-
ing the Delivery Method in Section 4. If the pump is already in the
IDM, you may select it again to clear all programming screens to their
default settings.
To Next Page
