Using Apollo
64 ©2020 CAE 905K351052 v1.1
CAEApollo
Genitourinary System
Apollo may beconfigured with either male or either of which allows for the insertion of a urinary
catheter.The genitourinary system also provides for the excretion of urine.
Changing the Simulator’s Genitalia
Apollo comes with male and female genitalia.
To change the genitalia:
1. Pull apart the Velcro holding the genitalia.
2. Loosen and remove the urethra connector. This connection may be tight
when genitalia are removed the first time.
3. Remove the genitalia.
4. Attach urethra tube to the urethra connector.
5. Attach the desired genitalia using the Velcro.
Urinary Catheterization
Apollo allows urinary catheterization and simulation of urinary output. Ensure all fluids have been
removed from previous uses before each new use to prevent overfilling. Catheterize the simulator
using a standard urinary catheter lubricated with silicone spray. The bladder for the simulated urine
is accessed directly via the urethra.
To simulate continuous urinary output:
1. Set up the IV pole near the simulator.
2. Fill an IV bag with the clinically appropriate fluid. Use distilled water only,
with food coloring if desired.
3. Hang the IV bag on the IV pole.
4. Ensure the roller clamp is closed and insert the IV spike into the IV bag.
To Next Page
Loading...
