CAE Juno - Step 1: Clean the Manikin; Step 2: Drain and Clean the Rectum; Step 3:Drain and Flush the IV

Care and Maintenance
86 ©2023 CAE 905K600152 v1.4
CAEJuno
Step 1: Clean the Manikin
To clean the simulator, use a soft cloth and warm water with a mild detergent to wipe off any
moulage materials on the manikin’s skin. Gently rub the soiled area with a soft cloth to remove most
marks and stains. DO NOT use solvents or abrasive pads.
Inspect the manikin for damage or puncture marks. If damage exists, contact CAE Healthcare
Customer Service immediately for a repair. Prompt repair prevents expansion of the damaged area.
Step 2: Drain and Clean the Rectum
If suppositories were administered, remove them. To drain the enema reservoir:
1. Cap the overflow port.
2. Attach syringe to enema fill/drain port on the manikin’s right side.
3. Aspirate fluids.
Note: To ensure the resevoir is completely empty, place manikin in an upright, 90-degree sitting
position and aspirate any additional fluid.
Step 3:Drain and Flush the IV
If the simulation included use of optional IV administration equipment, perform the following
procedure to remove fluids prior to storing the manikin:
1. Drain the remaining fluid from the IV tubes in the left arm.
2. If simulated blood was used, flushing the tubes with clear distilled water is recommended.
3. Fill a syringe with clear distilled water.
4. Attach the syringe to the appropriate IV prime port.