100 — C
ONSTRUCTION
M
ASTER
®
P
RO
/ T
RIG
/ D
ESKTOP
Converting Percent Grade to D:M:S, 80
Converting Roof Angle in Degrees to Pitch in Inches, 80
Converting Tangent/Pitch to Angle, 80
Cutting Boards, 29
Cylinder, Volume, 33
Default Settings, 82
Degrees:Minutes:Seconds, Converting, 78
Dimensional Measurement Unit Keys, 3
Dimensions (Linear), Entering, 18
Dimensions (Square/Cubic), Entering, 18
Dimensions, Adding, 24
Dimensions, Dividing, 24
Dimensions, Multiplying, 24
Dimensions, Subtracting, 24
Drywall, 52
Drywall Function (Not Available on Trig Model #4080), 9
Drywall Sheets, Number of (For a Given Area), 52
Drywall Sheets, Number of (For a Given Length), 52
Entering Dimensions, 18
Error Codes, 91
Examples, 29
Footing Function, 9
Grade/Slope, 53
Hip/Valley and Jack Rafter Keys, 11
Hip/Valley Rafter, 12
Irregular Pitch, 12
Irregular Side Jacks, 13
Irregular Hip/Valley and Jack Rafters, 62, 64
Jack Rafters, 12
Jack Rafters –
Using Other Than 16 Inch
, 61
Key definitions, 1
Lumber Estimation, 38
Memory and Storage Functions, 2
Memory Operation, 25
Multi-Function h Example, 32
Multi-Function W Example, 31
Paperless Tape Operation, 27
Percentage Calculations, 25
Pitch Ratio, 57
Polygon, Example, 49
Polygon Function, 9
Preference Settings, Appendix B, 83
Preferences, How to Set, 86
Rake-Wall Function, 13
Rake-Wall –
No Base
, 66
Rake-Wall –
With Base
, 67
Recall ® Key, 3
Regular Hip/Valley and Jack Rafters, 60
Reset, 92
Right Triangle and Roof Framing, 54
Right Triangle/Roof Framing Keys, 10
Rise, 59
Rise and Diagonal, 59
Roof Covering –
Entering Pitch, Length and Width
, 68
Roof Covering –
Entering Rise, Run (No Pitch) and Area
, 69
Roof Framing Definitions, 55
Roof Materials/Covering Function, 14, 68
Setting Fractional Resolution, 20
Sheathing Cut, 60
To Next Page
Loading...
Need help?
General
