U
SER
’
S
G
UIDE
— 27
PAPERLESS TAPE OPERATION
Note: Not available on DT (Desktop) Printer — Model #44065.
The Paperless Tape allows you to display and review the last twenty
entries of a regular math or basic dimensional math string calculation.
To access this mode after entering values, press ® =. Then,
press + or – to scroll forward or backward through the entries.
While in the Paperless Tape mode, the display will show the previously
entered or calculated value, along with the sequential number of
entry (e.g., 01, 02, 03, etc.) and the math operator (+, –, x, ÷, %) in
the upper left corner of the display.
Note: If
=
has been used in the middle of a string, SUB (for Subtotal) will display in
the upper left. If
=
was the last operation performed, the display will show TTL (Total)
as the last entry.
To exit this mode, press = to exit and maintain the last entry on the
display. When exiting, the last entry (or TTL) will be displayed, allow-
ing you to continue using the last tape value for another operation, if
desired.
Note: The Paperless Tape is cleared when:
-
o
is pressed twice;
- upon a new calculation (new equation string is started); or
- when the calculator is shut off.
Example:
KEYSTROKE DISPLAY
1. Enter a string of numbers:
4 f + 4 FEET 0 INCH
5 f + 9 FEET 0 INCH
6 f + 15 FEET 0 INCH
7 f = 22 FEET 0 INCH
2. Access the tape function:
® = TTL= 22 FEET 0 INCH
3. Scroll from first value to total:
+ 01 4 FEET 0 INCH
+ 02+ 5 FEET 0 INCH
+ 03+ 6 FEET 0 INCH
+ 04+ 7 FEET 0 INCH
+ TTL = 22 FEET 0 INCH
(Cont’d)
To Next Page
Loading...
Need help?
General
