U
SER
’
S
G
UIDE
— 83
The
Construction Master Pro
calculators have Preference Settings
that allow you to customize or set desired dimensional formats and
calculations. The options vary per model.
If you replace your batteries or perform a
Full Reset*
(press O, hold
down x, and press o), your calculator will return to the following
settings (in addition to those listed on the previous page):
*Depressing the Reset button located above the
p
key (below the
Ç
key on the
Desktop model) will also perform a Full Reset.
PREFERENCE OPTIONS
1) Fractional Resolution – *1/16 (displays fractional values to the
nearest 16th of an Inch)
– 1/32
– 1/64
– 1/2
– 1/4
– 1/8
2) Area Display Format – *Standard (if units entered are the
same—e.g., Feet x Feet—the answer
will remain in this format (Square Feet),
but if units entered are different — e.g.,
Inches x Feet—area answer will be dis-
played in Square Feet)
– Square Feet (area answers always
displayed in Square Feet, regardless of
unit entry — e.g., Inches x Inches =
Square Feet)
– Square Yards (area answers always
displayed in Square Yards — e.g.,
Feet x Feet = Square Yards)
– Square Meters (area answers always
displayed in Square Meters — e.g.,
Feet x Feet = Square Meters)
Note: To check the current Fractional Resolution, press
® /
. Either “Std” (standard
fractional resolution) or “Cnst” (constant) will be displayed, along with the fractional
resolution).
(Cont’d)
APPENDIX B —
PREFERENCE SETTINGS
To Next Page
Loading...
Need help?
General
