Calculated Industries 4080 v3.1 Construction Master Pro Trig User Manual

U SER ’ S G UIDE — 85
(Cont’d)
PREFERENCE OPTIONS
8) Irregular Jack Rafters – *OC-OC (On-center spacing maintained
O-C or Mate on both regular and irregular sides)
– JAC-JAC (regular/irregular Jack rafters
“mate” at the hip/valley, e.g., On-center
spacing not maintained on both sides)
9) Exponent Off or On – *Off (Exponential Mode is Off; turns
on Auto-ranging; e.g., if display can’t
show seven digits, will display in next
largest unit).
– On (Exponential Mode is On)
10) Meter Linear Display – *0.000 (linear Meter answers are
always displayed to third decimal place)
– FLOAt (linear Meter answers are
displayed to the maximum number of
decimal places — e.g., 1.234 M + 2.56 M
= 3.794 M)
11) Decimal Degree – *0.00°
Display – FLOAt
12) Fractional Mode – *Standard (fractions are displayed to
the nearest fraction)
– Constant (fractions are displayed in
the set fractional resolution)

Calculated Industries 4080 v3.1 Construction Master Pro Trig Specifications

General

Brand	Calculated Industries
Model	4080 v3.1 Construction Master Pro Trig
Category	Calculator
Language	English