Calix ODC-10 Installation Guide
29
Proprietary Information: Not for use or disclosure except by written agreement with Calix.
© 2001-2003 Calix. All Rights Reserved.
Connecting Power and Ground
Introduction
Connecting Power describes procedures for connecting cables and batteries for the
cabinet. The cabinet requires a 240-220 VAC power feed with 60 Amp service.
Ground, AC, and DC wiring diagrams are located in the Diagrams and Worksheets binder
that ships with the cabinet.
DANGER! High voltage may be present. Only a qualified electrician should install and
connect power cables. Install the power cables only after you have securely mounted the
cabinet and routed all cables inside. Follow NEC and local codes when installing AC
power.
Do not turn on the main power to the cabinet until the power installation is complete.
To Next Page
Loading...