Page
2 - Manual FA01806-EN - 01/2024 - © CAME S.p.A. - The contents of this manual may change, at any time, and without notice. - Translated original instructions
WARNING! Important safety instructions for people: READ CAREFULLY. Important safe-
ty instructions. Please follow all of these instructions. Improper installation may cause
serious bodily harm. Before continuing, please also read the general precautions for
users. Only use this product for its intended purpose. Any other use is hazardous. The
manufacturer cannot be held liable for any damage caused by improper, unreasonable
or erroneous use. This product is defi ned by the Machinery Directive (2006/42/EC) as
partly completed machinery. Partly completed machinery means an assembly which
is almost machinery but which cannot in itself perform a specifi c application. Partly
completed machinery is only intended to be incorporated into or assembled with other
machinery or other partly completed machinery or equipment thereby forming ma-
chinery to which the Machinery Directive (2006/42/EC) applies. The fi nal installation
must comply with the Machinery Directive (2006/42/EC) and the European reference
standards in force. The manufacturer declines any liability for using non-original
products, which would also void the warranty. All operations indicated in this manual
must be carried out exclusively by skilled and qualifi ed personnel and in full com-
pliance with the regulations in force. The device must be installed, wired, connected
and tested according to good professional practice, in compliance with the standards
and laws in force. All the components (e.g. actuators, photocells and sensitive edges)
needed for the fi nal installation to comply with the Machinery Directive (2006/42/
EC) and with the reference harmonised technical standards are specifi ed in the
general CAME product catalogue or on the website www.came.com. Make sure the
mains power supply is disconnected during all installation procedures. Check that the
temperature ranges given are suitable for the installation site. The appliance must be
powered with a voltage corresponding to the value shown on the rating plate. Power
must be supplied through a very low safety voltage system. Do not install the operator
on surfaces that could yield and bend. If necessary, add suitable reinforcements to
the anchoring points. Make sure that no direct jets of water can wet the product at the
installation site (sprinklers, water cleaners, etc.). Make sure you have set up a suitable
dual-pole cut-o device along the power supply that is compliant with the installation
rules. It should completely cut o the power supply according to category III surcharge
conditions. Demarcate the entire site properly to prevent unauthorised personnel from
entering, especially minors. In case of manual handling, have one person for every
20 kg that needs hoisting; for non-manual handling, use proper hoisting equipment
in safe conditions. Use suitable protection to prevent any mechanical hazards due to
persons loitering within the operating range of the operator. The electrical cables must
pass through special pipes, ducts and cable glands in order to guarantee adequate
protection against mechanical damage.
To Next Page
Loading...
Need help?
General
