CAME zl92 - Function Configuration - Part 1

F
i
0
i
F
i
0
F
2
8
F
i
0
F
5
F
i
0
3
F
3
2
4
4
i
i
i
2
2
3
3
ENTER
ENTER >
>
ENTER >
>
>
>
>
>
>
>
ENTER > > >
>
>
>
>
ENTER
>
>
>
>
ENTER
ENTER
ENTER
8
7
7
>...>
>...>
F
i
0
F
6
i
ENTER > > ENTER
>...>
P. 13 - Manual code: 319V21EN Vers. 3 04/2017 © CAME cancelli automatici S.p.A. - The data and information in this manual are subject to change at any time without prior notice required by Came Cancelli Automatici S.p.A.
ENGLISH
Functions menu
F 1 (Total Stop) : this function stops the gate and consequently excludes any automatic closing cycle; for movement to resume,
you need to use the keypad or transmitter. Insert the safety device on [1 -2]; if unused, select “0” function.
0 = Deactivated; 1 = Activated (default setting)
F 2 (CX input): the N.C. safety contact input can take on the following functions: C1 (re-opening when closing), C2 (re-closing
when opening), C3 (partial stop), C4 (obstacle stall), C7 (re-opening when closing, for sensitive edges), C8 (re-closing when
opening, for sensitive edges) or, be deactivated. See safety devices on electrical connections.
0 = Deactivated (default setting); 1 = C1; 2 = C2; 3 = C3; 4 = C4; 7 = C7; 8 = C8.
F 3 (CY Input): safety contact input can take on the following functions: C1 (re-opening when closing), C2 (re-closing when
opening), C3 (partial stop), C4 (obstacle stall), C7 (re-opening when closing, for sensitive edges), C8 (re-closing when opening, for
sensitive edges) or, be deactivated.
See safety devices on electrical connections.
0 = Deactivated (default setting); 1 = C1; 2 = C2; 3 = C3; 4 = C4; 7 = C7; 8 = C8.
F 5 (Safety Test) : allows the card to check the efficiency of any safety devices (i.e. photocells) after every opening or closing
command.
0 = Deactivated (default setting); 1 = CX; 2 = CY; 3 = CX+CY
F 6 (Maintained action) : the gate works by keeping the button pressed (button 2-3 for opening, button 2-4 for closing, or if set
to the “Closing” function, only with button 2-4. (This excludes all other command devices including radio commands).
0 = Deactivated (default setting); 1 = Activated.