CAME zl92 - Command and Control Devices; Device Integration and Setup

CANCELLI AUTOMATICI
R700
CANCELLI AUTOMATICI
R800
A B S1 GND
CAME
ACCESS CONTROL
P. 7 - Manual code: 319V21EN Vers. 3 04/2017 © CAME cancelli automatici S.p.A. - The data and information in this manual are subject to change at any time without prior notice required by Came Cancelli Automatici S.p.A.
ENGLISH
Stop button (N.C. contact) - Button to stop gate while
excluding the automatic closing cycle. For movement to
resume you must press the command button or transmit-
ter button.
N.B.: if the contact is unused, select “0” = (Disabled)
from the F1 functions menu.
Key selector and/or opening button (N.O. contact)
- Gate opening command.
Key selector and/or commands button (N.O.
contact) - Commands for opening and closing
the gate – pressing the button or turning the
key-switch, inverts the gate’s movement or
stops it depending on how it is set on the 2-7
command in the “FUNCTIONS” menu.
Key selector and/or partial opening button (N.O.
contact) - Partial gate opening for pedestrian
access.
Key selector and/or closing button (N.O. contact)
- Gate closing command.
001TSP00 - Transponder sensor
N.B. : insert the (R700) decoder
card to have the (TSP00) sensor or
(LT001) card reader recognised.
001LT001 - Magnetic card reader
Antenna with RG58
cable for the remote
control.
N.B. : insert the (R800)
decoder card to have
the (S7000) keypad
selector recognised.
Command devices
001S7000 – Keypad selector
Red
Black