CAME zl92 - Function Configuration - Part 6

F
i
05
0 I
I I
F
i
F33
06
03
i3
F
i
06
02
i2
ENTER
> >
ENTER
>
>
ENTER
> >
ENTER
>
>
F i3
>...>
>...>
F23
>...>
ENTER
ENTER
> >
>
>
F
i
I00
0 I
I I
ENTER
> >
ENTER
>
>
>...>
F43
F
i
I00
0 I
I I
ENTER
> >
ENTER
>
>
>...>
F53
F
i
0 I
I I
ENTER
> >
ENTER
>
>
>...>
F63
08
P. 18 - Manual code: 319V21EN Vers. 3 04/2017 © CAME cancelli automatici S.p.A. - The data and information in this manual are subject to change at any time without prior notice required by Came Cancelli Automatici S.p.A.
ENGLISH
F 31 (Slow-down speed of M2 motor) : setting the speed of the M2 motor during slow downs, calculated as a percentage.
20 = 20% motor slow-down speed (minimum); .................. 50 = 50% motor slow-down speed (default setting); .................
60 = 60% motor slow-down speed (maximum).
F 32 (Additional slow-down when closing of M1 + M2) : Setting of an additional reduction in speed during closing slow-downs
for the straight-arm M1 and M2 motors; the reduced speed is calculated as a percentage.
Note: this function only appears for the Myto, and Stylo straight-arm gearmotors.
10 = 10% motor slow-down speed (minimum); .................. 50 = 50% motor slow-down speed (maximum and default setting)
F 33 (calibration speed) : setting the speed only for the gate calibration phase, calculated as a percentage.
30 = 30% of the motor speed; ........ 50 = 50% of the motor speed (default setting); ...... 60 = 60% of the motor speed.
F 35 (Slow-down sensitivity) : adjusts the obstacle detection sensitivity during slow-downs.
10 = maximum sensitivity; .................. 100 = minimum sensitivity (default sensitivity).
F 34 (gate run sensitivity) : adjusts the obstacle detection sensitivity during the gate runs.
10 = maximum sensitivity; .................. 100 = minimum sensitivity (default sensitivity).
F 36 (Adjusting Partial Opening) : adjusts the opening of the gate leaf of the M2 (second) motor as a percentage of the total gate
run.
10 = 10% of the gate run (default setting); .................. 80 = 80% of the gate run.