CAME zl92 - Function Configuration - Part 2

F
i
0
F
7
F
i
0
F
8
F
i
0
F
9
F
i
0
F0 i
i
i
i
i
ENTER > > ENTER
ENTER >
>
ENTER
ENTER > > ENTER
ENTER > > ENTER
>...>
>...>
>...>
>...>
F i i
F
i
0
i
ENTER
>...>
> > ENTER
F
i
0
F2 i
i
ENTER > > ENTER
>...>
P. 14 - Manual code: 319V21EN Vers. 3 04/2017 © CAME cancelli automatici S.p.A. - The data and information in this manual are subject to change at any time without prior notice required by Came Cancelli Automatici S.p.A.
ENGLISH
F 7 (2-7Command) : setting the contact on 2-7 to step-by-step (open-close) or sequential (open-stop-close-stop).
0 = step-by-step (default setting); 1 = sequential.
F 8 (2-3P Command) : setting the 2-3P contact to pedestrian opening (second gate leaf opens fully) or partial (second gate leaf
opens partially depending on the time setting of the percentage between 10 and 80 of the gate run, function “F36”).
0 = pedestrian opening (default setting); 1 = partial setting.
F 9 (Obstacle detection) : when motor is stopped (gate closed or after a total stop command) it prevents any movement if safety
devices, such as photocells, detect any obstacles.
0 = Deactivated (default setting); 1 = Activated.
0 = gate open and moving, stays on (default setting)
1 = - gate opening, flashes on and off every half second;
F 11 (Exclude Encoder): excludes encoder from managing slow-downs, obstacle detection and sensitivity.
0 = Encoder activated (default setting); 1 = Encoder deactivated.
F 12 (Slowed-down thrust): at each opening or closing command, the gate leaves move slower for a few seconds.
0 = Deactivated (default setting), 1 = Activated.
- gate closing, flashes on and off every second;
- gate open, stays on;
- gate closed, stays off.
F 10 (Opening Warning light) : light bulb connected on 10-5, warns of gate status.