1 Description and scope of delivery
Thank you for purchasing your MFD28/32 Gen2. With the CANchecked data display, you can display
live data from your vehicle while driving, log sensors and use many other functions that are
presented to you in this manual.
This guide explains how to operate and handle your Gen2 data display. In addition to the connection,
setup and navigation, this manual deals specifically with the individual setting and the connection
and operation of our "Display Setup Software" (DSS).
You received your data display in a vehicle-specific mount or in one of our universal mounts.
Depending on your order configuration, the contents of your original packaging may vary. Always
included are:
• the quickstartguide
• 2 non reflective covers
• A SD card reader adapter
• CANchecked stickers
• One USB cable
• and either two Molex connectors (8 pin and 10 pin) and a choice of different pre-crimped
leads and two 1kohm resistors or a pre-terminated OBD cable
Your display itself has a capacitive touch screen, two Molex connectors on the back, a MicroUSB port
and a slot for a MicroSD card. The MicroSD card is always pre-assembled in your CANchecked data
display and described by us with data for your vehicle.
The sensors and page configurations are stored on the microSD card. For faster charging and display,
the display also has an internal flash memory. To remove the MicroSD card, after switching off the
display, the SD card must be pressed in slightly with a suitable object or fingernail to loosen the
latching nose. After pressing in, the MicroSD card springs out (please proceed carefully so that it
does not jump out uncontrollably).
Terms associated with the data display are shown in italics in this guide for better understanding.
To Next Page
Loading...
Need help?
General