4 Logging
To start and stop the log, press the button in the lower left corner after swiping up. Depending on
the active protocol (see chapter 6.26.2(without protocol) all sensors available in the TRI/TRX file are
logged. The logs are numerically incremented, and the button appears in green when the log is
active. If you press the green button again, the log will end. The display counts the logs up to 255
and then starts again at 0. This number is not customizable. On the SD card in the folder logs you will
find the log files after successful logging. Alternatively, you can use the Log Viewer in the DSS to
access your logs or delete them from the SD card. The logs are recorded every 62 ms (~16 Hz) and
should not exceed one hour due to the overview. You can read more about this in chapter 9.4
To Next Page
Loading...
Need help?
General