CAN CHECKED MFD28 Gen2 - Page 9

Rev 1.0
9
If you swipe down from top to bottom on your display (red arrow) you will be taken to the setup and
DTC (not available on all vehicles and protocols, more on this in chapter 6.2).
In the setup you can make all settings relevant for the operation of the display. The menu navigation
in the setup is described in chapter5
Figure 4: Setup and Quick Access Bar
If you swipe your finger from bottom to top (purple arrow) you open the quick access bar. These can
be accessed from any of the ten pages. Here you will find the button for logging, the slider for the
brightness of the display and a configurable custom button.