Printing procedure
9. Send the print job.
• Printing from Windows (→P .92)
• Printing from Mac OS X (→P .93)
Start printing.
Note
• Steps 6 and 7 are not required, if a barcode has been printed on the roll and you have activated
automatic detection of the remaining roll paper . The paper type and amount of paper left are
automatically detected.
• Keeping a roll in the printer for a long time without printing on it may leave a depression on the leading
edge.
When printing quality is most important, we recommend setting T rimEdge Reload to On or Automatic
so that the paper edge is automatically cut before printing.
• For details on supported sizes and types of the roll that can be loaded, see “Paper Sizes” or the Paper
Reference Guide . ( → P .106) ( → P .101)
• Clean the platen after you have used up a roll. ( → P .495)
• When a roll has been advanced, do not pull it out by force. This will prevent the paper from being
advanced. ( → P .1 17)
If you accidentally pull out the paper , see “Roll Paper Cannot be Inserted into the Paper Feed Slot”.
(→P .514)
• When printing on rolls after printing on sheets, if the lit paper selection lamp does not switch from the
Cut Sheet lamp to the Roll Media lamp , press the Feeder Selection button.
Basic Printing W orkow 89
To Next Page
Loading...
Need help?
General
