Canon imagePROGRAF iPF605 - Gl2: W0502 the Parameter Is out of Range; Gl2: W0504 this Command Is Not Supported; There Is no Data

Messages regarding HP-GL/2
Messages regarding HP-GL/2
This type of paper is not compatible with HP-GL/2.
Cause Corrective Action
Replace the paper with a type compatible with
HP-GL/2. For details on paper compatible with
HP-GL/2, refer to the Paper Reference Guide .
( → P .101)
The printer has received a HP-GL/2 print job that
cannot be printed on the paper that has been
advanced.
The printer may continue printing, but the printing
quality may be af fected. Check the printing results.
There is no data.
Cause Corrective Action
The data was lost because of replotting. Data for replotting is lost after the following
operations. In this case, send the print job again.
• The memory buf fer was cleared from the Control
Panel .
• The printer was turned of f.
• The printer received a new print job.
GL2: Wxxxx The memory is full. (xxxx is 0501, 0903, or
0904)
Cause Corrective Action
The printer memory is full. Because the entire print job could not be received,
the printer may not be able to print the entire original.
Check the printing results.
GL2: W0502 The parameter is out of range.
Cause Corrective Action
A parameter specied in a HP-GL/2 command is out
of the supported range.
Check the print job.
GL2: W0504 This command is not supported.
Cause Corrective Action
The printer has received an unsupported HP-GL/2
command.
Check the print job.
552 Error Message