Cannot print over a network
Cannot print over a NetW are network
Cause Corrective Action
The printer ’ s NetW are settings are not congured
correctly .
Make sure the printer ’ s NetW are settings are
congured correctly . In particular , make sure a valid
frame type is selected. For details, see “Conguring
the Printer ’ s NetW are Network Settings”. (→P .425)
The computer you are trying to print from is not
congured correctly .
Make sure the computer ’ s NetW are settings are
congured correctly . For details, see “Conguring
NetW are Network Settings”. (→P .443)
The NetW are server and services are not congured
correctly .
Check the following points.
1. Make sure the NetW are le server is running.
2. Make sure there is enough free disk space on the
NetW are le server . Insuf cient disk space may
prevent you from processing large print jobs.
3. Start NW ADMIN or PCONSOLE and conrm that
the print service is congured correctly and the
print queue is available.
4. If data transmission to a printer on another subnet
fails, deactivate NCP burst mode in that printer ’ s
network protocol settings.
5. If the printer is used in queue server mode, specify
“Other/Unknown” as the printer type.
The printer was turned of f and on when not
disconnected from the server .
Leave the printer of f for at least 30 seconds, and
then restore power .
Cannot print over AppleT alk or Bonjour networks
Cause Corrective Action
The AppleT alk protocol is not enabled on the printer . Activate AppleT alk on the printer .
( → P .424)
The computer you are trying to print from is not
congured correctly .
Make sure the computer ’ s AppleT alk settings are
congured correctly .
( → P .447)
( → P .452)
The computer and printer are not on the same
network.
Due to the nature of Bonjour , you cannot print if
the printer is on another network behind a router .
Make sure the computer and printer are on the same
network. For information about network settings, ask
your network administrator .
T roubleshooting 527
To Next Page
Loading...
Need help?
General
