Control Panel
GL2 Settings
Setting Item Description, Instructions
GL2 Replot Print the last printed job (still stored in the printer memory) again.
GL2 BufferClear Delete the last job printed using HP-GL/2, still stored in the printer memory .
Color Mode Choose the color mode.
Print Quality Choose the print quality .
Input Resolution Choose the printer input resolution, 600dpi or 300dpi .
Media Source Choose the media source forHP-GL/2 printing.
Conserve Paper Conserves paper when printing.
Line Cap Choose the shape of the end point, determined by Software or Rounded .
• If you choose Software
Operation is determined by the application. If nothing is specied by the application,
the result is as shown in the gure.
• If you choose Rounded
Smoothing Choose whether to print arcs as smooth curved lines or as multiple connected line
segments.
• If you choose Software
Operation is determined by the application. If nothing is specied by the application,
the result is as shown in the gure.
Note: By default, this is a 72-sided gure
• If you choose Smooth
Line W idth Choose the width for printing lines if no width is specied in the data. Dots in the line
width are 300 dpi each.
ThickenFineLines Select On to print ne lines more distinctly .
AdjustFaintLines If ne lines are printed in colors that do not match the colors of other shapes, selecting
Off may help produce the expected results. However , lines in some colors may
appear broken.
Printer Parts 59
To Next Page
Loading...
Need help?
General
