Network Setting
Conguring the Printer ’ s TCP/IP Network Settings
Follow the steps below to congure the TCP/IP network settings.
1. Start the web browser and enter the following URL in the Location (or Address ) box to display
the RemoteUI page.
http:// “printer IP address or name” /
Example: http://xxx.xxx.xxx.xxx/
2. Select Administrator Mode and click Logon .
3. If a password has been set on the printer , enter the password.
4. Click Network in the Device Manager menu at left to display the Network page.
5. Click Edit in the upper-right corner of the TCP/IP group to display the Edit TCP/IP Protocol
Settings page.
6. Refer to the TCP/IP Settings Items table to complete the settings.
TCP/IP Settings Items
Item Details
Default Setting
Use DHCP Activate this setting to use DHCP
for conguring the IP address.
Of f
Use BOOTP Activate this setting to use
BOOTP for conguring the IP
address.
Of f
Use RARP Activate this setting to use RARP
for conguring the IP address.
Of f
Enable DNS Dynamic Update Activate this setting to perform
DNS server registration
automatically .
Of f
Use Zeroconf Function Activate this setting to use
Bonjour .
On
IP Address Specify the printer ’ s IP address. 0.0.0.0
Subnet Mask Specify the printer ’ s subnet mask. 0.0.0.0
Gateway Address Specify the printer ’ s default
gateway .
0.0.0.0
LPD Printing Activate this setting to use LDP
Printing.
On
IPP Printing Activate this setting to use IPP
Printing.
On
IPP Printer URI Specify the URI of the printer
used for IPP printing using up to
252 characters.
When using a standard Windows
port for IPP printing, enter an
URL less than 255 bytes for
all characters for “http://"IP
address"/IPP-URI.”
printer
RA W Printing Activate this setting to use Raw
Printing.
On
422 Network Setting
To Next Page
Loading...
Need help?
General
