Printheads
15. Pull the Printhead Fixer Cover down toward the front to lock the Printhead in place.
16. Push the Printhead Fixer Lever toward the back of the printer until it clicks.
17. Close the T op Cover .
Ink now lls the system.
After about ten minutes, the Printhead alignment will be automatically adjusted, and the printer
will go online.
If no paper has been loaded, a message is displayed requesting you to load paper .
Important
• Never remove an Ink T ank while the system is lling with ink.
• If Auto Print is Off in the printer menu, the Printhead alignment will not be adjusted. In this case,
adjust the alignment after Printhead replacement by accessing Auto Head Adj. in Advanced
Adj. . ( → P .453 )
486 Maintenance
To Next Page
Loading...
