Cannot print over a network
Cannot print over a network
Cannot connect the printer to the network ................................................................................................................ 598
Cannot print over a TCP/IP network ..............................................................................................................................598
Cannot print over a Bonjour network ............................................................................................................................ 598
Cannot connect the printer to the network
Cannot connect the printer to the network
Cause Corrective Action
The Ethernet cable is
not connected cor-
rectly to the printer's
Ethernet port.
1.
Make sure the printer is connected to the network with the correct Ethernet cable, and then turn the printer
on. For instructions on connecting the cable, refer to the Setup Guide.
2.
Make sure the Link indicator is lit.
The bottom indicator is green if the printer is connected via 1000Base-T, while the top indicator is orange if
connected via 100Base-TX and the top indicator is green if connected via 10Base-T.
If the Link indicator is not lit, check the following points.
•
Make sure the connection point is on.
•
Make sure the end of the Ethernet cable is connected correctly.
Insert the Ethernet cable until it clicks and locks in place.
•
Make sure there is no problem with the Ethernet cable.
If there is any problem, replace the Ethernet cable.
•
Check the communication mode with the connection point.
Although the printer normally detects the communication mode and transmission rate of the communica-
tion point automatically (in auto negotiation mode), sometimes the communication point settings cannot
be detected. In this case, configure the connection method manually, specifying the communication mode
in use.
(See "Configuring the Communication Mode Manually.") ➔ P.498
Cannot print over a TCP/IP network
Cannot print over a TCP/IP network
Cause Corrective Action
The printer's IP address is not configured cor-
rectly.
Make sure the printer's IP address is configured correctly.
(See "Configuring the IP Address Using imagePROGRAF Device Setup Utility.") ➔ P.500
(See "Configuring the IP Address Using the Printer Control Panel.") ➔ P.488
The printer's TCP/IP network settings are not
configured correctly.
Make sure the printer's TCP/IP network settings are configured correctly.
(See "Configuring the Printer's TCP/IP Network Settings With RemoteUI.") ➔P.492
The computer you are trying to print from is not
configured correctly.
Make sure the computer's TCP/IP network settings are configured correctly.
(See "Configuring the Printer Driver Destination (Windows).") ➔ P.491
(See "Configuring the Destination in TCP/IP Networks (Mac OS).") ➔ P.496
Cannot print over a Bonjour network
Cannot print over a Bonjour network
Cause Corrective Action
The computer you are trying to
print from is not configured correct-
ly.
Make sure the computer is configured correctly.
(See "Configuring the Destination for Bonjour Network (Mac OS).") ➔ P.496
The computer and printer are not
on the same network.
Due to the nature of Bonjour, you cannot print if the printer is on another network behind a router.
Make sure the computer and printer are on the same network. For information about network set-
tings, ask your network administrator.
Cannot connect the printer to the network
iPF680
User's Guide
Troubleshooting Cannot print over a network
598
To Next Page
Loading...
Need help?
General
Weight and Dimensions
