Other Maintenance
Important
• Attach the Belt Stopper , which was removed and stored after initial installation. Neglecting to attach
the Belt Stopper may damage the printer .
• Do not touch the Linear Scale (a), Carriage Shaft (b), or Fixed Blade (c).
17. Close the T op Cover .
18. T ape down printer covers to secure them, in the reverse order of tape removal during installation.
19. If the Output Stacker is installed, reverse the installation procedure to remove the Output Stacker .
20. Remove the Stand by reversing the installation procedure, when it was attached to the printer .
21. T o disassemble and repackage the Stand , follow the procedure for printer installation with six
people (that is, installation by lifting the printer) in reverse.
Caution
• Do not reverse the installation procedure that involves tipping the printer over . This may damage the
printer . For more information, see the Quick Start Guide .
22. Repack the Roll Holder , Holder Stopper , and printer in the shipping materials, and then package
them in the shipping box.
Maintenance 727
To Next Page
Loading...
Need help?
General