Problems with the printing quality
The surface of the paper is dirty
Cause Corrective Action
The Paper Retainer is soiled. Clean the Paper Retainer . ( → P .718)
Y ou are using a paper that does not dry easily . Specify a time of about a minute in Roll DryingT ime .
The back side of the paper is dirty
Cause Corrective Action
Open the T op Cover and clean the Platen .
( → P .718)
The Platen has become dirty after borderless printing
or printing on small paper .
Set CarriageScanWdth to Fixed .
The Platen has become soiled due to printing on the
Platen because width detection is deactivated.
Activate width detection, and open the T op Cover and
clean the Platen .
( → P .718)
The Paper Retainer is soiled. Clean the Paper Retainer . ( → P .718)
Banding in different colors occurs
Cause Corrective Action
The paper feed amount is not adjusted correctly . Adjust the feed amount.
( → P .654)
Printing does not proceed smoothly because print
jobs are interrupted during transmission.
Exit other applications and cancel other print jobs.
In the printer menu, Print Length is specied in
Feed Priority .
Selecting Band Joint may improve printing results.
Adjust the feed amount in the printer menu by
specifying Band Joint in Feed Priority and try
printing again.
( → P .654)
The Printhead is out of alignment. Adjust the Printhead alignment.
( → P .649)
Streaks may occur if you set the Print Quality too
low .
Choose a higher level of Print Quality in the
Advanced Settings of the printer driver and try
printing again.
( → P .241)
742 T roubleshooting
To Next Page
Loading...
Need help?
General