Cutter Unit
Cutter Unit
Cutter Unit
A reaplacement Cutter Unit .
• Cutter Unit CT -06
Note
• For instructions on replacing the Cutter Unit , see “Replacing the Cutter Unit”. (→P .703)
Replacing the Cutter Unit
Note
• For information on compatible Cutter Unit , see “Cutter Unit”. (→P .703)
1. T urn the printer on. ( → P .18)
2. Press the Menu button to display MAIN MENU .
3. Press ▲ or ▼ to select Maintenance , and then press the ► button.
4. Press ▲ or ▼ to select Change Cutter , and then press the ► button.
5. Press ▲ or ▼ to select Y es , and then press the OK button.
After the Carriage is centered, a message is shown on the Display Screen instructing you to
open the T op Cover .
Note
• If you do not respond within two minutes, cutter replacement is canceled and the printer goes online
automatically . In this case, repeat this procedure.
6. Open the T op Cover .
Maintenance 703
To Next Page
Loading...
Need help?
General