Other problems
Paper cannot be cut
Cause Corrective Action
In the printer driver , No or Print Cut Guideline is
specied in Auto Cut .
Specify Y es in Auto Cut in the printer driver .
In MAIN MENU , Eject or Manual is specied in
Cutting Mode .
Specify Automatic in Cutting Mode in MAIN MENU .
The Cutter Unit is not installed. Install the Cutter Unit .
( → P .703)
Rolls are not cut when you are using the Media
T ake-up Unit .
Either execute Paper Cutting in the Control Panel or
lift the Release Lever and cut the roll with scissors.
( → P .237)
The printer does not go on
Cause Corrective Action
The printer is unplugged. Plug the power cord into the outlet, and then turn on
the printer .
The specied voltage is not supplied. Check the voltage of the outlet and breaker .
For information on the specied voltage, see
“Specications”. (→P .133)
Roll paper cannot be inserted into the Paper Feed Slot
Cause Corrective Action
The roll paper is warped. Straighten out curls and reload the roll.
Cannot Load Sheets
Cause Corrective Action
The paper source selection is incorrect. Press the Feeder Selection button to activate the
Cut Sheet lamp .
758 T roubleshooting
To Next Page
Loading...
Need help?
General