To change the setting, select Settings.
â—¦ Enable/disable Wired LANâ—¦
Select Enable when connecting to wired LAN.
Note
• By selecting Advanced, you can set LAN in detail.•
For the items that can be set, see the following.
Advanced
• Print details•
Prints out the LAN setting information of the printer with Wi-Fi connection, wired LAN connection,
wireless direct connection.
Important
• Important information on your computer is stated on the paper on which the LAN setting information
is printed. Please handle with care enough.
Note
• You can also print out the LAN setting information by selecting the following.•
(Setup) > Printer settings > Test print > Print LAN details
• Advanced•
By selecting Advanced on each setting screen of Wi-Fi connection, wired LAN connection, wireless
direct connection, LAN information can be set in detail.
Important
• If the LAN is disabled, the following items can not be selected.
â—¦ Set printer nameâ—¦
Specifies the printer name. You can use up to 15 characters for the name.
Note
• You cannot use the same printer name as that already used for other LAN connected devices.
• You cannot use a hyphen for the initial or last character of the printer name.
â—¦ TCP/IP settingsâ—¦
Performs IPv4 or IPv6 setting.
â—¦ WSD settingsâ—¦
Setting items when you use WSD (one of the network protocols supported in Windows).
â–ª Enable/disable WSDâ–ª
Selects whether WSD is enabled or disabled.
352
To Next Page
Loading...
Need help?
General