2
2
2-45
2-45
Technology > MEAP > Enhanced System Application Management > Procedure Changing Login Services
Technology > MEAP > Enhanced System Application Management > Procedure Changing Login Services
Enhanced System Application Management
■
Outline
[ Enhanced System Application Management ] mainly manages the login services for logging
in to devices.
• Installing and uninstalling Enhanced System Application Management (login services, etc.)
• Switching login services (switching the method to log in to devices)
• Checking installation status of other System Applications
F-2-97
■
About Login Service
The login service is started up to authenticate the user when MEAP-enabled iR device is
booted up. Login service changes and install/ uninstall are carried out from the 'System
Management' page.
The pre-installed login application is Default Authentication, and the default setting is [ Start ].
■
Default Authentication overview
Default Authentication is a pre-installed login application that runs by default. It provides
authentication functions to allow minimum operation of the Controller System, even when no
other login application is running.
■
Other Log in service
There are login services besides the foregoing Default Authentication, such as card
authentication. For details, refer to the manuals for those login services.
■
Procedure Changing Login Services
If 2 or more login services are installed, you can use the following procedure to switch among
them.
1) Access SMS. From the [ System Management ] menu, select [ Enhanced System
Application Management ].
F-2-98
To Next Page
Loading...
