Maximum Volume [VOL]
You can limit the maximal settable volume with this (protective) function Maximum Volume in such way that the sound level (indicated in the speaker’s
display) cannot be turned up above the set value. You can set the desired volume level from 0 to 70, where 70 represents the maximum.
To change the maximum volume, proceed as follows:
1
To enter the menu, press and hold the input select key
" "
for at least 3 seconds.
2
Use the
"+"
or
"-" button
to navigate into the menu System Setup [SYS] and confirm with the Play/Pause button " ".
3
Select the item Maximum Volume [VOL] and confirm with the Play/Pause button " ".
4
Select the wanted volume value using the “+” or “-“ key.
5
Press the input select key
" "
to exit this menu item
Note: This function does not limit the output volume level of the speaker to a certain level but only the selectable volume. Based on the incoming signal
(level) the output volume can be higher or lower.
Factory Reset [RES]
With this function [RES] you can reset the speaker to its factory settings.
Caution: ALL settings you have made, transmitted IR codes, paired (mobile) devices and speakers will be deleted
To perform the reset, proceed as follows:
1
Power up the speaker by pressing the Power-key " " .
2
Enter the menu by pressing and holding the input select key " " for at least 3 seconds. The display shows [SPS].
3
Press the "+" or "-" key until System Setup [SYS] is indicated in the Display.
4
Press the key Play/Pause button " ". The display shows [SLP].
5
Press the "+" or "-" key until Factory Reset [RES] is indicated in the Display.
6
Press the key
Play/Pause button " "
. The display shows [NO].
Note: To cancel the reset procedure, press the input select key " ". The display shows [RES] again. Press this key additional two times to exit the menu.
7
To execute the reset, press the "+" key. The display flashes [YES] for 5 seconds.
8
The display then shows [OK] to confirm the reset procedure and the LED flashes red/green alternately.
9
After around 15 seconds the speaker reboots. During this procedure the display flashes [ON] and the LED flashes green fastly. This
procedure lasts up to 60 seconds.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
