To change the way in which the paring process is initiated, proceed as follows:
1
To enter the Menu, press and hold the input select key
" "
for at least 3 seconds
2
Use the
"+"
or
"-" button
to navigate into the menu
Wireless Setup [WIS]
and confirm with the Play/Pause button " ".
3
Select
the function Bluetooth
®
Setup [BT]
and confirm with the Play/Pause button " ".
4
Select
the item Pairing Mode [BTP]
and confirm with the Play/Pause button " "
.
5
Use the "+" or "-" key to select the desired parameter [MAN] or [AUT].
[AUT] = The device sends the pairing request permanently (automatic mode).
[MAN] = The request is activated by pressing the "Bluetooth Pairing" button only on the optional remote control.
6
Press the input select key
" "
to exit this menu item.
Notes: • If a signal is being transmitted via Bluetooth wireless technology, the Soundbox 3 does not send a pairing request to a second
mobile device, even if the automatic mode [AUT] is selected.
• If the input [BT] is not selected, neither automatic nor manual pairing is possible. To achieve pairing independent of the
selected input, the BT Select [BTS] function must be set to [AUT]. Please refer to the next chapter.
• The requirements for a successful pairing process are indicated in the chapter “Playback via Bluetooth® wireless technology".
BT Select [BTS]
When this function is enabled [AUT], the speaker automatically switches to the input [BT] whenever it detects an audio signal from a
(mobile) device. If this function is deactivated [MAN], the input must be selected manually.
To activate / deactivate this function, proceed as follows:
1
To enter the Menu, press and hold the input select key
" "
for at least 3 seconds
.
2
Use the
"+"
or
"-" button
to navigate into the menu
Wireless Setup [WIS]
and confirm with the Play/Pause button " ".
3
Select the function Bluetooth
®
Setup [BT]
and confirm with the Play/Pause button " "
.
4
Select the item BT Select [BTS]
and confirm with the Play/Pause button " "
.
5
Use the "+" or "-" key to select the desired parameter [MAN] or [AUT].
6
Press the input select key
" "
to exit this menu item.
Note: Depending on the (mobile) device used, the speaker may also switch to the input [BT] when a message is typed or other
system tones are received when the automatic mode [AUT] is activated. A time delay of 5 seconds is programmed to avoid
continuous switching (e.g. on arrival of a message).
Note: If the BT Select function is activated [AUT], the input [BT] cannot be selected via the Input
" "
key any longer.
In this mode, the speaker can be paired with the (mobile) device anytime, regardless of the selected signal input.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
