EasyManua.ls Logo

Carrier i-Vu Open Link - Document Revision History

Carrier i-Vu Open Link
38 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Document revision history
i-Vu Open Link Carrier Proprietary and Confidential CARRIER CORPORATION ©2017
Installation and Start-up Guide All rights reserved
31
Important changes to this document are listed below. Minor changes such as typographical or formatting errors are not
listed.
Date
Topic
Change description
Code*
2/6/17
BACnet firewall
New topic
C-D-RD-BL
1/16/17
To communicate using PuTTY
Screen capture updated
C-FW-DE-O
To wire a BACnet/ARC156 network
New topic
C-D
Ethernet, BACnet MS/TP, and ARC156
Added BACnet ARC156. Changed wiring guide to Open Controller
Network Wiring Guide
C-
D
Wiring for communications
Added BACnet ARC156.
C-D
Specifications
Added BACnet ARC156 connection.
C-D
Cover
What is the i
-Vu® Open Link?
Changed to latest controller image.
C-D
9/16/16
Communication LED's
Corrected 0, added 8.
C-D
6/6/16
Wiring for communications
To wire Modbus or LonWorks devices
on Port S2
Added note to set the Router Config Mode DIP switch for Console
to off when using Port S2.
C-D-LJ-E-RD
6/2/16
To take the i
-Vu® Open Link
out of
service
New topic
C-D-LJ
To assign a custom IP address
Updated for PuTTY and v6.5
C-D-TS-E-RR
Notification Class #1
Updated for i-Vu® v6.5
C-D-LJ
1/15/16
Specifications
Correction. Environmental Operating Temperature changed from
0 to 140°F to -20 to 140°F
C-D-LJ-RD
8/6/14
Specifications
Power - BACview references removed
Battery - Expanded information on the archive function, low
battery, and touchscreen added
Protection - surge events defined as "lasting no more than 10
msec"
BACnet support - Conformance standards listed
C-D-LJ
To assign a custom IP address
BACview reference removed
C-D-LJ
Configuring i-Vu® Open Link Driver
Properties > Driver
Added new driver property: Touchscreen Schedule Edit Enable
C-D-LJ
Restore factory defaults
Added information on using the Factory Defaults button
C-D-LJ-E-RD
* For internal use only
Document revision history

Related product manuals