CAS CL5200 Series - Printer Hardware (Menu Code 1730)

12
5
2.13.3 Printer Hardware (Menu code 1730)
( MENU → 7. Print → 1. Printer Hardware )
This section is to explain how to set printing H/W environments in the
following table.
1. Press “3” to get into H/W setting
mode on Print Menu.
▶ Printer Hardware Sub-Menu
No. Sub-menu Description
1 Print Mode Select label, ticket or continuous label mode.
2
Label / Ticket
Size
If it is Label mode, “Width(60)”, “Height(40)” and “Gap
length(2)” size is set, If it is Ticket mode, “Width(60)”,
“Feed(20)” and “End Margin(30)” size is set. If you use
Continuous Label Paper in Label mode, “Gap length” value
is applied to “End Margin”.
* The values in ( ) are default.
3
Sensor
Calibration
Enter the “Gap(128)” and “Peel(128)” values for printing
sensor calibration.
* The values in ( ) are default.
* If you press “TEST” key, Gap and Peel values are
adjusted automatically.
* In case of Ticket mode, Gap value is not saved.
4 Sensor & Motor Set Peel-off sensor, Rewind Motor and Label Paper type
5 Print Intensity Set the extent of intensity of label (ticket) printed.
6
Adjust Feed
Length
Set adjusting values of feed length.
This value can be from -200 to +200. You can change
sign(+, -) by pressing ZERO key.
+ value will print higher than THP.
* Pressing “TEST” key automatically feeds to adjust the
feed length.