9
2.10 Programming Cutting Hall
2.10.1 Cutting Hall (Menu code 1360)
( MENU → 3. PLU Date Table II → 6. Cutting Hall )
This menu is used to program Cutting Hall information. Cutting Hall information is
used when programming Traceability Numbers. Therefore Cutting Hall information
programming should be completed prior to programming Traceability.(Menu 1330)
2.10.1.1 New/Edit Cutting Hall (Menu code 1361)
( MENU → 3. PLU Date Table II → 6. Cutting Hall → 1. New/Edit )
▶You can press the SAVE key at anytime to save the current data and if
you want to exit without saving, press the ESC key.
1. Enter cuttting hall number
• This value can be from 1 to 99
EX) Cutting hall no. = 1
2. Enter cutting hall information
• Enter cutting hall name or registered
number.
EX) Cutting hall registered number = KSH12
3. Cutting hall Country number
• You can use country number which is
programmed at menu 1341 (See page 74)
EX) Cutting Hall Country no. = 1.
KOREA
4. Exit menu
• If you want to exit, press ESC key.
To Next Page
Loading...
