④ Remove the item(s) from the platter.
Note: - If you set “LABEL” to “Y” in menu 1872 of program mode, the scale does
not check peel-off, so you have to press FEED key after printing is done.
(See chapter 2.14.21)
- If parameter 551, “Use double print(auto)“ is set, you will have
two same labels in auto mode.
- If you set 2nd label in PLU programming, 2nd label is issued automatically.
3.14.2 Non-Weighed PLU
You can use X key for by Count, By PCS PLU without any setting. The way
of using X key is same as by-weight PLU except weighing item.
To Next Page
Loading...
