CAS CL5200J Series - Scanner Config (Menu Code 1464)

92
3. Delete Conv Table )
1. Enter the number of Conversion Table to be deleted
EX) Delete Conversion Table no. 2
Note: There is no confirmation request when deleting a Table No. Pressing the
PRINT key will cause the Conversion Table No. entered to be deleted.
2.7.6.3 Scanner Config (Menu code 1464)
( MENU → 4. Store Data Table → 6. Scanner → 4. Scanner Config )
1. The way to set up Scan Form
Enter defined 13-digit number or letter that scanner can recognize.
Assigned representative characters are written below.
-“X” character : It must be the number of same digit length as “Mapping Code”, that you entered
above, has.
-“W” character : It represents weight date.
Any other symbol than “X”, “W” is ignored when scanning.