26
4) The display shows “S kEy 0”. Press the Preset key (1 to 54) you wish to program.
The number in the UNIT PRICE display is the number of the Preset key you have just pressed.
The number in the TOTAL PRICE display is the PLU number that has been assigned to that Preset key.
5) Type the number of the PLU you wish to assign to that preset key. Press the PRT/* key when done.
6) If you want to program another preset key go back to step
2). If you wish to finish PROGRAM mode press the C key
4.4 Message (Ingredients) Programming
LP-1000N is able to have maximum 1000 messages. Each message has up to 8 lines of text and each line
contains up to 50 characters.
To Next Page
Loading...
