12
2.2 PLU Keypad
The PLU Keypad is used to enter alpha-numerical data. To use the keypad for programming you must
remove the pull-out sheet. To use the PLU Keypad in REG mode, you can write the name and number
of the PLU’s on the corresponding speed keys on the pull-out sheet.
All commodity names, message data, and store name and address are typed using these keys.
The scale automatically programs the PLU Keypad to be PLU 1 to 54. A speed key’s number is shown
circled on the lower left-hand side of each key.
To Next Page
Loading...
