47
4.7.8 Programming Baud Rate (SET #9)
How to program baud rate
1) To go to PROGRAM mode, press 1 by using numeric keys and MODE key.
2) Press v key five times.
3) The WEIGHT display shows “SEt”.
4) Press PRT/* key, “SEt EntEr”.
5) Press 9 key and PRT/* key.
6) The display shows “bAUd EntEr 3=9600”.
7) Look at table below and type number that you want.
<RS232c Baudrate>
‘1’ = 2400bps
‘2’ = 4800bps
‘3’ = 9600bps
‘4’ = 19200bps
‘5’ = 38400bps
‘6’ = 57600bps
8) Press PRT/* key. The display shows “SEt”.
9) If you wish to finish PROGRAM mode, press C key.
To Next Page
Loading...
