28
How to program the head data
1) To go to PROGRAM mode press 1 by using numeric keys and MODE key.
2) Press v key three times, the display shows “HEAd”.
3) Press PRT/* key. The display shows “HEAd 01.01”. The numbers in the UNIT PRICE display
represent the line number and character number on which your cursor is at.
The number to the left of the decimal is the line number you are on(01 to 01).
The number to the right is the number of the character position on which you are(01 to 30).
4) Type in the NON-PLU commodity name using the Alpha-numeric keypad.
If you make any mistakes press C key. You may now begin typing your head data using your
Alphanumeric keypad. After you type each line press ENTER key when you are done typing a line.
If you wish to skip a line press v key. If you want to go up a line press v key.
Press s key or t key to scroll left or right on a line of text. As you type you will see the text scroll
in the TOTAL PRICE display.
5) Press PRT/* key.
6) If you wish to finish PROGRAM mode press C key
4.6 Programming
The shop data are the 2 lines of text that get printed on the bottom of the label when it is not suppressed
by the label format. You can use these two lines to print the name and address of the store or anything
else you wish the scale to print at the bottom. Each line contains 30 characters of text.
To Next Page
Loading...
