27
1) To go to PROGRAM mode press 1 by using numeric keys and MODE key.
2) Press v key two times. The display shows “MSG”.
3) Press PRT/* key. The display shows “MSG 1000 ”.
4) Type the number of the MSG you wish to program or edit using the Numeric Keypad.
Remember, the number can be from 1 to 1000. If you make any mistakes press the C key
and repeat step 4.
5) Press the PRT/* key. The display shows : “MSG 01.01”. You may now begin typing your MSG data
using your Alpha-numeric keypad. Each message has 8 lines of text and each line contains 50 characters.
After you type each line press ENTER key when you are done typing a line. If you wish to skip a line
press the v key. If you want to go up a line, press the u key. Press s key or t key to scroll left or right
on a line of text. As you type you will see the text scroll in the TOTAL PRICE display.
6) When you are done press PRT/* key, the display shows “SAvE” and then press the PRT/* key.
If you do not want to save it press v key, the display shows “ESC” and then press the PRT/* key.
If you want to edit it press v key until the display shows “Edit” and then press the PRT/* key.
7) If you wish to program another MSG go back to step 2). If you wish to finish PROGRAM
mode press the C key
4.5 Programming
The header or head data is two lines of commodity name that appears on a label when you generate
a Non-PLU label.
To Next Page
Loading...
