7
1. Installation Procedures
1.1 Cautions
A) Environment : This scale must be installed in a dry and liquid free environment.
B) Location : This scale must be placed on a flat and stable surface. Please keep the scale away from
oscillating fans, ventilation systems, or drafts as these air disturbances can be picked-up by the scale
and may cause incorrect weight readings.
C) Leveling : If the scale is not properly level, please adjust the 4 legs at the bottom of the scale
(turn legs clockwise or counter-clockwise) so as to center the bubble of the leveling gauge inside the
indicated circle. (See below Fig.)
LEVELING GAUGE
NOTE : Scale is to be used in-doors ONLY
D) The socket-outlet shall be installed near the equipment and shall be easily accessible.
E) Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type
recommended by the manufacturer. Dispose of used batteries according to the manufacturer instructions.
1.2 How to assemble the DISPLAY Pole
If the scale is "Pole" type, please refer to the following
However, the scale is "Non-Pole" type, please skip this step.
Please confirm the SCREW and DISPLAY WIRE before you assemble the scale.
(Refer to the following picture)
To Next Page
Loading...
